At some time it was hard to see that text had been selected because the "text selected" colour was almost exactly the same as the normal colour. You should be able to copy text from the wiki! I just tried it (again) in both Firefox 10 and Internet Explorer 8 and they worked fine. But why am I unable to do a cut and paste from this wiki? What is the point of making people type up the commentary? -March 3, 2012 That bell noise is even more annoying than those alarm clocks from the 80's. Nothing feels better than disabling those bells when you hit Esc if you're already outside of insert mode. The gvimrc file is in the same directory as vimrc see vimrc for the proper file name.Īwesome. To avoid that possibility, use:Īnother method to disable beeping and flashing is to put a command into your vimrc to handle terminal Vim, and another command into your gvimrc to handle gvim. The above will give an error message if run on a Vim which was not compiled with the +autocmd feature. The same commands can be entered using abbreviations: This works on Unix and Windows systems for both terminal and GUI Vim. To disable beeping (aka "bell") and window flashing, put the following in your vimrc. ![]() If the option is empty, Vim does not flash the screen.ĭisable beep and flash with an autocmd The t_vb option controls how Vim flashes the screen (on both Unix and Windows systems, for both terminal and gui Vim). However, pressing Esc should also do nothing (no beep and no flash). Entering :set xyz will give the same result as before (a message but no beep or flash). However, pressing Esc should flash Vim's screen (a "visual bell").Įnter the command :set t_vb= to clear the t_vb option (so it will do nothing). Entering :set xyz will give the same result as before. However, other "errors" such as pressing Esc when in normal mode will cause a beep.Įnter the command :set vb to set visualbell. depends on your system):ĭue to noerrorbells, no beep occurs when an error message is displayed. Display the default settings by entering: Enter the command :set xyz and observe that an error message is displayed, but no beep occurs. If your sound system is working, you should hear your system's version of a "bell" (often a beep). Start Vim with no initializations from vimrc or gvimrc, but using 'nocompatible' mode: That is achieved by entering the command :set vb t_vb= after the GUI has started-see method 1 or method 2 below.Ī demonstration is useful to show how the options work. ![]() If 't_vb' is cleared and 'visualbell' is set, no beep and no flash will ever occur. If 't_vb' is cleared, Vim will never flash the screen-however, it has to be cleared after the GUI has started. Starting the GUI (which occurs after vimrc is read) resets 't_vb' to its default value. The 't_vb' option, by default, is set to a code that will cause the screen to flash. If it is on (that is, if :set visualbell is used), Vim will flash its screen instead of sounding a beep (that is, at times when a beep would have occurred, the screen will flash instead). The 'visualbell' (abbreviated as 'vb') option is off by default. The 'errorbells' option has no effect on the beeps that Vim makes when an error message is not displayed (for example, on pressing Esc when in normal mode). If 'errorbells' is on, the error message will attempt to either sound a beep or flash Vim's screen. For example, the command :set xyz displays an error message because 'xyz' is not a valid option. If it is on (that is, if :set errorbells is used), Vim will either beep or flash its screen when an error message is displayed. The 'errorbells' (abbreviated as 'eb') option is off by default.
0 Comments
Leave a Reply. |